Rear Window Shade Motor, Removing and Installing

Rear Window Shade Motor, Removing And Installing

Removing
- Remove hatshelf.







- Remove bolt - 1 - of drive disc - 2 - and pull out drive disc.







- Separate tie wrap - 3 -.
- Remove connector - 4 -.
- Remove screws - 2 -.
- Remove rear window shade motor - 1 -.
- Check form of drive gear in drive disc.







- An intact star shaped drive gear (arrow) permits installation of motor without further measures.
- If hexagon-drive gear or star shaped drive gear drive disc are worn, replace drive disc for new star shaped gear from small parts set.

Installing







- Fasten rear window shade motor - 1 - with bolts loosely to bracket.







- Install drive disc - 2 - in drive gear of motor, if necessary.
- Replace bolt - 1 - for drive disc and tighten with bolt.

Tightening torque: 8 Nm (71 in.lb.)

- Apply a voltage of 12 V to rear shade motor and let shade come down completely.







- Tighten bolts - 2 - with shade rolled up securely.

Tightening torque: 8 Nm (71 in.lb.)

- Apply a voltage of 12 V to rear shade motor and let shade come down completely.
- Roll shade up again several times.







- If lever arm is not completely extended, loosen screws - 2 - and slide motor into slots.
- Left lever arm extends earlier: Slide motor to right.
- Right lever arm extends earlier: Slide motor to left.
- Check, if necessary, that lever arms move evenly.
- Connect connector - 4 - to motor control module for rear shade and secure using tie wrap - 3 -.
- Install hatshelf.