Center Console, Removing and Installing

Center Console, Removing And Installing

- Make auxiliary tool for disassembly of outlet.







- Bend wire of 3 mm diameter as shown in illustration. Dimension - x - = 6 mm
- Remove speaker mounting for telephone.
- Position seats all the way back.
- Remove floor left and right cover.
- Turn accelerator pedal stop 1/4 revolution (90 degrees) further.







- Remove screws - 1 - and- 2 -.
- Remove trim left for center console - 3 - (to remove, slide trim forward and unhook from back).







- Remove screws - 2 - and - 3 -.
The front screws - 2 - can be reached by turning back floor covering.
- Remove right-side trim for center console - 1 -.
To remove, slide trim forward and unhook from back.
- Pull up parking brake lever as far as possible.







- Pry out lock pin - 2 - in direction of (arrow - A -).
- Remove parking brake lever handle - 1 - in direction of (arrow - B -).







- Pry off cover - 1 - and loosen lock bolt (arrow) approx. 2 rotations.
- Remove trim plate for trim - 2 - from front.







- Remove parking brake trim.
Note the retaining tab at the rear/narrow end of the trim.

Vehicles with manual transmission:
- Remove shift knob and place in 4th gear.

Vehicles with center armrest:
- Remove center armrest.

All vehicles:







- Unclip trim - 2 -.
- Remove screws - 3 -.
- Remove rear seat outlet - 1 -.







- Place auxiliary tool - C - in holes of instrument cluster outlets - D -.
- Remove instrument cluster outlet, center part out evenly.

NOTE: Do not hook auxiliary tool - C - into fins of instrument cluster outlet (the fins could break off).







- Remove 5 bolts (arrows).
- Remove instrument cluster, center part - 1 - and disconnect connectors.







- Remove bolts - 4 - left and right.
- Press ashtray - 1 - toward front.
- Remove screws - 3 -.
- Using sharp knife, separate, where necessary, adhesive between center console - 2 - and instrument panel.
- Raise rear center console and guide to front over parking brake lever.