Noise Insulation Panel, Assembly Overview

1 - Quick-release screw
- Remove only this quick release screw for service position
- Three pieces
- 2 Nm (18 in. lb)
2 - Front noise insulation
3 - Quick release screw
- Three pieces
- If rear noise insulation panel is also -4- being installed, then longer quick-release screws must be used
- 2 Nm (18 in. lb)
4 - Rear noise insulation panel
- Only installed for certain engine types
- Installed over noise insulation panel -2-
5 - Quick-release screw
- Two pieces
- 2 Nm (18 in. lb)
6 - Mounting for noise insulation panel
- Position -9- must face left side of vehicle
7 - Bolt
- Two pieces
- 7.5 Nm (66 in. lb)
8 - Plate nut
- Two pieces
9 - Plate nut
- Three pieces
10 - Clamping pin
- Two pieces
11 - Wheelhousing liner
12 - Bumper
13 - Lock carrier with attachments