Check DTC Memory (Function 02)

NOTE: The displayed malfunction is only updated when the On Board Diagnostic (OBD) program is initiated or when "Erase DTC Memory" function 05 is used.

- Switch on printer by pressing PRINT button (indicator lamp in button lights up).

Indicated on display
Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2- to select "Check DTC Memory" function 02.

Indicated on display
Rapid data transfer Q
02 - Check DTC Memory

- Press -Q- button to confirm input.

Indicated on display (the number of stored malfunctions)
X DTC recognized!

- Stored malfunctions are displayed and printed out one after the other.
- Check printout against DTC table and repair all malfunctions as necessary.
- If "No DTC recognized" is displayed the program will return to the starting point ("Select function XX" prompt) after the -> button is pressed.

No DTC recognized!

Indicated on display
Rapid data transfer HELP
Select function XX

If anything else is displayed:
- See Scan Tool operating instructions.
- End output (function 06). Ending Output (Function 06)
- Switch ignition oft and disconnect connections from Data Link Connector (DLC).