Rear

Exploded View Of Rear Hub And Spindle:

LEGEND
1. Rear axle beam
2. Bolt
3. ABS wheel speed sensor
4. Clamping sleeve
5. Bracket for ABS wheel speed sensor cable
6. Nut
7. Bolt and washer assembly
8. ABS wheel speed sensor rotor
9. Wheel hub

NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.

COMPONENT NOTES
Rear Axle Beam (1)
- Supplied as service part with sleeve for mounting ABS wheel speed sensor.

Bolt (2)
- Tighten to 10 Nm (7 ft. lbs.).

ABS Wheel Speed Sensor (3)
- Pull out to remove.
- Left and right sensors are identical.
- Before installing, coat with brake assembly lube and press in by hand until seated.
- Both ABS wheel speed sensor harness connectors are located under the rear seat bench.

Clamping Sleeve (4)
- Before installing, coat with brake assembly lube.
- Press into wheel bearing housing until seated.

Bracket For ABS Wheel Speed Sensor Cable (5)
- Attach to side member of rear axle.

Nut (6)
- Tighten to 10 Nm (7 ft. lbs.).

Bolt And Washer Assembly (7)
- Tighten to 30 Nm (22 ft. lbs.).

ABS Wheel Speed Sensor Rotor (8)
- To remove, insert drift through holes in wheel hub and drive off evenly.

Wheel Speed Sensor Rotor (Toothed Ring) Installation:

- To install, press on using tools as shown in illustration.

Wheel Hub (9)
- Refer to Transmission and Drivetrain for service information.