Rear Center Console, Assembly

Rear center console, assembly





CAUTION! Disconnect battery Ground (GND) strap before working on any part of electrical system.

Note: Before removing parking brake lever trim, center console must be removed.


1 - Gear lever knob
^ Unscrew before removing center console
2 - Gear lever trim
^ Unclip from retaining clip -13- and remove upward before removing center console
3 - Screw
^ 5.0 Nm (44 in lb)
4 - Screw
^ 1.5 Nm (18 in lb)
5 - Lining
6 - Rear air duct
^ Remove before installing center console
Removing:
- Unclip trim plate for cigarette lighter -8- and unscrew self-tapping screws -7- located underneath
- Lift up lining -5- and unscrew self-tapping screw -4- located underneath
- Pull out rear air duct and unplug electrical connectors
7 - Self-tapping screw
^ 1.5 Nm (18 in lb)
8 - Cigarette lighter trim plate
9 - Bolt
^ 5.0 Nm (44 in lb)
10 - Rear center console
Removing:
- Slide driver's and passenger seats all the way forward
- Pull up parking lever as far as possible
- Carefully press handle off lug of insert on handle underside with screwdriver and pull off
- Remove screws -3-, bolts -9-
- Lift out center console over parking lever forward at angle
11 - Speed nut
12 - Handle
^ Remove before removing center console
13 - Retaining clip